Sony Clock Radio ICFCS10IP User Manual

Note  
Adjusting the AM loop antenna  
Find a place and an orientation that provide good  
reception.  
4-150-697-11(1)  
Important Safety  
Instructions  
Owners Record  
e model number and the serial number are located on the  
bottom.  
Record the serial number in the space provided below. Refer  
to them whenever you call upon your Sony dealer regarding  
this product.  
When you replace the battery, do not disconnect  
the plug from the AC outlet. Otherwise, the  
calendar, current time, alarm and station presets  
will be initialized.  
Compatible iPod  
models  
Specifications  
AUDIO POWER SPECIFICATIONS  
POWER OUTPUT AND TOTAL HARMONIC  
DISTORTION:  
With 6 ohm loads both channels driven, from  
150 -10,000 Hz; rated 3 watts per channel  
minimum RMS power, with no more than 10 %  
total harmonic distortion.  
Time display  
12-hour system  
iPod section  
DC out: 5V  
MAX: 500mA  
1) Read these instructions.  
Do not place the AM loop antenna near the  
2) Keep these instructions.  
unit or other AV equipment, as noise may  
result.  
Compatible iPod models are as follows. Update  
3) Heed all warnings.  
your iPod to use the latest software before you use  
it.  
4) Follow all instructions.  
Model No. ICF-CS10iP  
Tip  
5) Do not use this apparatus near water.  
6) Clean only with dry cloth.  
Adjust the direction of the AM loop antenna for  
best AM broadcast sound.  
Serial No.________________________________  
7) Do not block any ventilation openings.  
Install in accordance with the manufacturers  
instructions.  
For customers who purchased this product in the  
USA  
Please register this product on line at  
Proper registration will enable us to send you  
periodic mailings about new products, services,  
and other important announcements. Registering  
your product will also allow us to contact you  
in the unlikely event that the product needs  
adjustment or modification. ank you.  
8) Do not install near any heat sources such as  
radiators, heat registers, stoves, or other  
apparatus (including amplifiers) that produce  
heat.  
Preparing the remote  
commander  
iPod nano  
4th generation  
(video)  
iPod touch  
2nd generation  
iPhone 3G  
Before using the card remote commander for the  
first time, remove the insulation film.  
9) Do not defeat the safety purpose of the  
polarized or grounding-type plug. A polarized  
plug has two blades with one wider than the  
other. A grounding type plug has two blades  
and a third grounding prong. The wide blade  
or the third prong are provided for your safety.  
If the provided plug does not fit into your  
outlet, consult an electrician for replacement  
of the obsolete outlet.  
10)Protect the power cord from being walked on  
or pinched particularly at plugs, convenience  
receptacles, and the point where they exit  
from the apparatus.  
11)Only use attachments/accessories specified by  
the manufacturer.  
Radio section  
Frequency range  
FM/AM  
Clock Radio  
Reset button  
Band  
FM  
Frequency  
Channel step  
WARNING  
To reduce the risk of fire or electric shock, do  
not expose this apparatus to rain or  
moisture.  
To reduce the risk of fire, do not cover the  
ventilation of the apparatus with newspapers,  
tablecloths, curtains, etc. And do not place lighted  
candles on the apparatus.  
To reduce the risk of fire or electric shock, do not  
expose this apparatus to dripping or splashing,  
and do not place objects filled with liquids, such  
as vases, on the apparatus.  
87.5 – 108 MHz 0.1 MHz  
530 – 1 710 kHz 10 kHz  
iPod nano 3rd  
generation (video)  
AM  
CR2032  
General  
Speaker  
iPod classic  
iPod touch  
When to replace the battery  
With normal use, the battery (CR2025) should  
last for about six months. When the remote  
commander no longer operates the unit, replace  
the battery with a new one.  
Approx. 5.7 cm (2 1/4 inches) dia. 6 Ω  
Input  
AUDIO IN jack (ø 3.5 mm stereo minijack)  
Power output  
3.5 W + 3.5 W (at 10% harmonic distortion)  
Power requirements  
120 V AC, 60 Hz  
For clock back up: 3V DC, CR2032 battery (1)  
Operating Instructions  
ICF-CS10iP  
iPod nano 2nd  
generation  
(aluminum)  
12)Use only with the cart, stand, tripod, bracket,  
or table specified by the manufacturer, or sold  
with the apparatus. When a cart is used, use  
caution when moving the cart/apparatus  
combination to avoid injury from tip-over.  
iPod 5th  
generation (video)  
iPhone  
Do not install the appliance in a confined space,  
such as a bookcase or built-in cabinet.  
Dimensions  
Dream Machine is a trademark of Sony Corporation.  
Do not expose the batteries (battery pack or  
batteries installed) to excessive heat such as  
sunshine, fire or the like for a long time.  
Approx. 290.5 × 152.0 × 139.5 mm (w/h/d)  
(11 3/8 × 5 15 16 × 5 1/2 inches) including projecting  
/
CR2025  
parts and controls  
Mass  
iPod nano 1st  
generation  
As the main plug is used to disconnect the unit  
from the mains, connect the unit to an easily  
accessible AC outlet. Should you notice an  
abnormality in the unit, disconnect the main plug  
from the AC outlet immediately.  
iPod 4th  
generation  
iPod 4th generation  
(color display)  
13)Unplug this apparatus during lightning storms  
or when unused for long periods of time.  
14)Refer all servicing to qualified service  
personnel. Servicing is required when the  
apparatus has been damaged in any way, such  
as power-supply cord or plug is damaged,  
liquid has been spilled or objects have fallen  
into the apparatus, the apparatus has been  
exposed to rain or moisture, does not operate  
normally, or has been dropped.  
For the state of california, USA only  
Perchlorate Material –special handling may apply, see  
Perchlorate Material: Lithium battery contains  
perchlorate  
Approx. 1.94 kg (4 lb 4 oz) including power  
supply unit  
Supplied accessories  
Remote commander (1)  
AM loop antenna (1)  
Audio connecting cable (1)  
Universal dock adapter for iPhone (1)  
Universal dock adapter for iPhone 3G (1)  
The unit is not disconnected from the AC power  
source (mains) as long as it is connected to the  
wall outlet, even if the unit itself has been turned  
off.  
If the time in the display is  
incorrect after the battery is  
changed (Reset)  
Notes  
Do not attempt to charge the battery.  
iPod mini  
If you are not going to use the remote  
commander for a long time, remove the battery  
to avoid any damage that may be caused by  
leakage and corrosion.  
No Power No Problem is a trademark of Sony Corporation.  
Notes  
Design and specifications are subject to change  
without notice.  
The nameplate and important information  
concerning safety are located on the bottom  
exterior.  
Press the reset button with a pointed device. The  
reset button is in the small hole located in the  
battery compartment (see Fig. ).  
In these Operating Instructions, “iPod” is used  
as a general reference to iPod functions on an  
iPod or iPhone, unless otherwise specified by  
the text or illustrations.  
The connector of the unit is for sole use with an  
iPod. If you use devices that do not match with  
the connector, connect to the AUDIO IN  
terminal of this unit with the supplied audio  
connecting cable.  
©2009 Sony Corporation  
Printed in China  
You are cautioned that any changes or  
modifications not expressly approved in this  
manual could void your authority to operate this  
equipment.  
Connecting the  
antenna  
About the backup  
battery  
CAUTION  
Danger of explosion if battery is incorrectly  
replaced. Replace only with the same type.  
To connect the AM loop  
antenna  
To keep accurate time, this unit contains a  
CR2032 battery as a backup power source.  
The battery keeps the clock and the alarm  
operating in the event of a power interruption.  
Precautions  
Sony cannot accept responsibility in the event  
that data recorded to an iPod is lost or damaged  
when using an iPod connected to this unit.  
Play the unit on the power source specified in  
“Specifications.”  
The shape and the length of the antenna is  
designed to receive AM signals. Do not dismantle  
or roll up the antenna.  
Since a strong magnet is used for the speaker,  
keep personal credit cards using magnetic coding  
or spring-wound watches away from the unit to  
prevent possible damage from the magnet.  
Do not leave the unit in a location near a heat  
source such as a radiator or airduct, or in a  
place subject to direct sunlight, excessive dust,  
mechanical vibration, or shock.  
NOTE  
Knowing when to replace the  
battery  
This equipment has been tested and found to  
comply with the limits for a Class B digital device,  
pursuant to Part 15 of the FCC Rules. These limits  
are designed to provide reasonable protection  
against harmful interference in a residential  
installation. This equipment generates, uses and  
can radiate radio frequency energy and, if not  
installed and used in accordance with the  
Troubleshooting  
1 Remove only the loop part from the  
plastic stand.  
2 Set up the AM loop antenna.  
When the battery becomes weak, “” appears in  
the display.  
Should any problem persist after you have made  
the following checks, consult your nearest Sony  
dealer.  
If a power interruption occurs while the battery is  
weak, the current time and alarm will be  
initialized.  
The clock flashes “AM 12:00” due to a power  
interruption.  
Allow adequate air circulation to prevent internal  
heat build-up. Do not place the unit on a surface  
(a rug, a blanket, etc.) or near materials (a  
curtain) which might block the ventilation holes.  
Should any solid object or liquid fall into the unit,  
unplug the unit and have it checked by qualified  
personnel before operating it any further.  
To clean the casing, use a soft cloth dampened  
with a mild detergent solution.  
Never touch the wire of the external FM  
antenna during a thunderstorm. Furthermore,  
immediately disconnect the AC power cord  
from the radio.  
Replace the battery with a Sony CR2032 lithium  
battery. Use of another battery may cause a fire or  
explosion.  
instructions, may cause harmful interference to  
radio communications. However, there is no  
guarantee that interference will not occur in a  
particular installation. If this equipment does  
cause harmful interference to radio or television  
reception, which can be determined by turning  
the equipment off and on, the user is encouraged  
to try to correct the interference by one or more  
The battery is low. Replace the battery. Remove  
the old battery and install a new one.  
The radio, iPod or buzzer alarm does not  
sound at the preset alarm time.  
Note  
If AM 12:00” flashes in the display when the unit  
is connected to an AC outlet for the first time, the  
battery may be weak. In this case, consult your  
Sony dealer.  
Check that alarm A” or alarm “B” is properly  
displayed.  
3 Insert the AM antenna terminal into the  
AM ANTENNA jack on the rear of the  
unit.  
The radio or iPod alarm is activated but no  
sound comes on at the preset alarm time.  
of the following measures:  
— Reorient or relocate the receiving  
antenna.  
Replacing the battery  
Check the alarm volume setting.  
1 Keep the AC plug connected to the AC  
outlet, remove the screw that secures the  
battery compartment lid at the bottom of  
the unit using a screwdriver, and open  
the lid (see Fig. ).  
2 Insert a new battery in the battery  
compartment with the side facing up  
(see Fig. ).  
3 Close the battery compartment lid and  
secure it with the screw (see Fig. ).  
4 Press iPod & iPhone , RADIO  
BAND, AUDIO IN or SNOOZE/DATE/  
SLEEP OFF to turn “” off in the  
display.  
— Increase the separation between the equipment  
and receiver.  
There is no sound from the iPod.  
Make sure the iPod is securely connected.  
Adjust the VOLUME.  
— Connect the equipment into an outlet on a circuit  
different from that to which the receiver is  
connected.  
NOTES ON LITHIUM BATTERY  
Wipe the battery with a dry cloth to assure a  
good contact.  
The iPod cannot be operated with this unit.  
— Consult the dealer or an experienced radio/TV  
technician for help.  
Be sure to observe the correct polarity when  
installing the battery.  
Make sure the iPod is securely connected.  
The iPod cannot be charged.  
Do not hold the battery with metallic tweezers,  
otherwise a short-circuit may occur.  
WARNING  
Make sure the iPod is securely connected.  
Replace the battery for the clock backup with a  
Sony CR2032 lithium battery, and the battery  
for the remote commander with a Sony CR2025  
lithium battery. Use of another battery may  
present a risk of fire or explosion.  
Battery may explode if mistreated. Do not  
recharge, disassemble or dispose of in fire.  
Dispose of used battery promptly. Keep away  
from children.  
When Daylight Saving Time (summer time)  
begins, the clock does not employ the  
Daylight Saving Time automatically.  
If you have any questions or problems concerning  
your unit, please consult your nearest Sony dealer.  
To remove the AM loop  
antenna  
Make sure the clock is set correctly.  
Press and hold CLOCK and SNOOZE/DATE/  
SLEEP OFF simultaneously for at least  
2 seconds to activate the Automatic DST  
function.  
Pull the AM antenna terminal while pushing up  
the terminal clamp.  
Features  
Clock Radio with iPod/iPhone 3G compatible  
Wake or Sleep to iPod/Radio/Buzzer  
Easy to set A-B alarm  
2-5-7day alarm  
LCD Brightness control  
MEGA BASS  
MEGA Xpand  
Wireless Remote Commander  
This unit includes a preinstalled Sony Lithium battery (CR2032) as back-up power source for the clock, which is preset  
to EST (Eastern Standard Time) at the factory. And this battery is considered part of the product.  
 

Singer Sewing Machine 114W101 User Manual
Soleus Air Air Conditioner PH 3 12R 03 User Manual
Speco Technologies Speaker SP 250W User Manual
Stanley Black Decker Portable Generator GTR20 User Manual
Stanton Turntable STR8 30 User Manual
StarTechcom Network Router sv431dusb User Manual
Sterling Marine Battery SSPET 5 User Manual
Sunbeam Fryer DF2100 User Manual
SUPER MICRO Computer Switch SAS2 826EL User Manual
System Sensor Smoke Alarm A05 1003 002 User Manual